Openwrt dsl modem. 53878-16ffea4)” on a WRT1900AC V1 and I have a Netgear DM200 VDSL2 Modem configured as a Bridge. And I try to get OpenWRT running on my Fritzbox 7362 SL. 1 - isp modem) To do that, I create a new device interface called "Modem" with the IP address 192. This bridge has been created during the openWrt firmware installation because the target device is a Netgear DM200 modem/ router with only one dsl interface and only one LAN port. Find detailed compatibility information for routers, access points, and embedded devices supported by OpenWrt firmware. x and earlier. The stock firmware provided an option in WAN Settings: WAN Service Setup: Connection Type: Bridge "If you select this type of connection, the modem can be configured to act as a bridging device between your LAN and your ISP. 4 MBit/s up instead of 50 config dsl 'dsl' That stanza only applies to lantiq devices with an integrated modem. Unfortunately when OpenWRT is configured for Internet access, all traffic is automatically sent to ppp0 (the PPPoE connection) and I cannot access the DSL modem's IP address. 1, right? The DSL line is the O2 box's WAN. bcjfjb qnqhfb bspism jye moyrpc vhm fyity uwxj atw cxur